Archive

Posts Tagged ‘Soil Surface’

Coconuts and Ginger Intercropping

January 2nd, 2010 arnx No comments

coconut-tree-ko-kutGinger can be grown in sandy loam, clay loam, and lateritic soils, provided that the soil is at least 30 cm. deep and there is enough rainfall and good drainage in the area.

Preparing the seed pieces:

1. Select fresh and healthy seed pieces weighing at least 20 grams each and showing signs of early sprouting.
2. Before planting, wash the seed pieces in running water. Then soak them for 10 to 15 minutes in a solution of acidulated mercuric bichloride (for every 20 liters water, add 45 grams captan).

Land preparation:

1. Prepare raised beds one week before planting to ensure good drainage. Beds with two rows should be about 30 cms. high and less than two meters wide. Row lengths depends on the farmers convenience. When beds are located in areas with high occurrences of soil-borne diseases, such as damping-off, the beds must be sterilized by burning dried rice straw, banana leaves or coconut leaves three times on the soil surface.

2. Plant the seed pieces about five cms. deep in each hill 25 cms. apart in double row in each bed. Arrange the hills in a triangular pattern, whether the seed pieces are planted in poorly drained areas or areas. When planted under coconut trees, the seed pieces should be planted 25 to 20 cms. in shallow furrows 45 cms. apart.

3. At the time of planting, fertilize the soil with complete fertilizer (12-24-12), 400 kg. if soil is sandy, 300 kg. if soil is clay-loam per hectare.

4. After planting, mulch the beds or ridges with green leaves (either ipil-ipil or madre de cacao) or rice straw, 10,000 kg./hectare, to prevent the soil from drying and to prevent erosion caused by monsoon rains.

5. During the second and fourth months of growth, apply fertilizer again. Generally, they should be weeded at least twice during its growth period.
Harvesting: Ginger should be harvested when the leaves become yellow and start to wither. This occurs eight months after planting.

6. In small harvesting areas, the crop is dug with a spading fork, the plant is pulled out, shakes off the soil and lays them on the bed. Stems are cut off without breaking the ginger bulbs.

7. In large plantation areas, ginger is harvested by harrowing the soil, then dried an open shaded area.

Source: Greenfields, March 1990; and http://elgu2.ncc.gov.ph

Garlic Farming

June 10th, 2008 arnx No comments

Garlic grows well in clay, alluvial and sandy loam soils. Sandy loam, properly applied with fertilizer, generally produces big, compact and heavy bulbs of good quality. Heavier soils such as clay loam also give profitable yields if they are cultivated and fertilized properly. Garlic requires cool weather during the early stage of growth thus it is best to plant them on the months of October and November.

Prepare the pieces of cloves in the afternoon, the day before planting. Carefully separate the cloves from each other, taking care not to injure them. Choose only the big pieces for planting. Soak the cloves for two minutes in a solution of Malathion prepared by mixing three tablespoonfuls in five gallons of water). Treating the cloves with Malathion would kill the microscopic mites that cause “tangle top,” a common garlic disease. Drain off the solution and put the cloves in a clean container for planting.

Land Preparation:

If the field is weedy and/or the soil surface is very irregular, plow and harrow the land thoroughly to kill weed seeds and to produce a fine, firm, smooth and level surface. Broadcast the recommended amount of fertilizers and mix thoroughly with the soil before leveling the field. For one hectare, use 125 to 175 kilos each of urea (45-0-0) and 14-14-14 or 12-24-12 NPK fertilizers. Mix the two fertilizers thoroughly. If urea is not available, use 235 to 270 kilos of ammonium sulphate. Mix with 115 to 130 kilos of 14-14-14 or 12-24-12 fertilizers. After applying the fertilizers and levelling the field, spread rice straw evenly throughout the entire paddy to a thickness of about 5 cms.

Irrigate the field just enough to moist the soil. In a few days, the field is ready for planting. In planting, mark the rows with the use of parallel lines of string spaced 20 cms. apart and placed just on top of the straw mulch. Hold the clove between the thumb and forefinger and set one-fourth of the clove into the soil. Then press the soil slightly but firmly towards the clove. Plant the cloves at intervals of 20 cms. in the row.Garlic does not need much irrigation. As long as there is sufficient soil moisture, bulb formation would be normal.

The plants are ready to be harvested as soon as three-fourths of the tops or leaves become fully ripe or dry. Lift the matured plants gently from the ground and then arrange the direct heat of the sun.

Pests and Diseases:

The important pests of garlic are mites and cut worms. Cut worms can be controlled by spraying the plants with solutions of: EPN-300 at three tablespoonfuls in five gallons of water plus sticker; and Imidan 50 W.P. at three tablespoonfuls in five gallons water plus sticker. Against mites, use Tedion V-18 at three tablespoonfuls of water. Spray the plants once a week. Pink Root which can be prevented only by planting resistant varieties.

Source:http://elgu2.ncc.gov.ph, photo courtesy of savoringkentucky.com